Honeywell AMH-10000E Troubleshooting, Condition Of Purchase, Maintenance, Specifications, English

Models: AMH-12000E AMH-10000E

1 88
Download 88 pages 24.36 Kb
Page 7
Image 7
TROUBLESHOOTING

NOTE:

Do not drop the remote control.

DO not place the remote control in a location exposed to direct sunlight.

The remote control should be placed about 1 meter or more away from TV or any electrical appliance.

Battery Replacement

Remove the cover on the back of the remote control and insert the batteries with the + and – poles pointing in the proper direction (Fig. 11).

CAUTION:

Use only AAA or IEC R03 1.5V batteries. Remove the batteries if the remote control is not used for a month or longer. Do not attempt to recharge the supplied batteries. All batteries should be replaced at the same time; do not mix old and new batteries. Do not dispose of the batteries in a fire, as they may explode.

TROUBLESHOOTING

The following cases may not always be a malfunction; please check your unit before asking for service.

My air conditioner does not run.

Check to see if the protector trip or a fuse is blown

Please wait for 3 minutes and start again.

The batteries in the remote might need replacing.

Check to see if the plug is properly plugged in.

My air conditioner runs for only a short time.

The temperature might be set close to the existing room temperature.

An air outlet might be blocked.

My air conditioner runs, but is not cooling.

A door or window may be open.

There may be a heater or lamp in operation

The air filter may need to be cleaned.

An air outlet or intake may be blocked.

The temperature may be set too high.

My air conditioner will not run, and the WATER FULL indicator light is on.

Drain the water into a prepared container by the drainage pipe on the rear panel of the unit.

If this does not work, please consult a qualified technician.

ENGLISH

Air Filter Maintenance

It is necessary to clean the air filter after using it for about 100 hours. Clean it as follows:

1.Stop the appliance and remove the air filter.

2.Clean and reinstall the air filter. If the dirt is conspicuous, wash it with a solution of detergent in lukewarm water. After cleaning, dry it in a shaded and cool place, then reinstall it.

3.Clean the air filter every two weeks if the air conditioner operates in an extremely dusty environment.

Maintenance Before Storage

1.If the appliance will not be used for a long time, be sure to pull out the rubber plug of the drain port underside, in order to drain the water.

2.Keep the appliance running on fan mode only for a half day to dry the appliance inside and prevent from getting moldy.

3.Stop the appliance and unplug it, then take out the batteries of the remote control and store them.

4.Clean the air filter and reinstall it.

5.Remove the air hoses and keep them well, and cover the air hole tightly.

6.Store your air conditioner covered in a cool dry place.

Disposal

This symbol on the product or its packaging indicates that the appliance cannot be treated as normal domestic trash, but must be handed in at a collection point for recycling electric

and electronic appliances. Your contribution to the correct disposal of this product protects the environment and the health of your fellow men. Health and the environment are endangered by incorrect disposal. Further information about the recycling of this product can be obtained from your local town hall, your refuse collection service, or in the store at which you bought the product.

CONDITION OF PURCHASE

As condition of purchase the purchaser assumes responsibility for the correct use and care of this KAZ product according to these user instructions.

WARNING: IF PROBLEMS ARISE WITH THIS KAZ PRODUCT, PLEASE OBSERVE THE INSTRUCTIONS IN THE WARRANTY CONDITIONS. DO NOT ATTEMPT TO OPEN OR REPAIR THE KAZ PRODUCT YOURSELF, AS THIS COULD LEAD TO TERMINATION OF THE WARRANTY AND CAUSE DAMAGE TO PERSONS AND PROPERTY.

Technical modifications reserved.

MAINTENANCE

Appliance Maintenance

1.Cut off the power supply. Turn off the appliance first before disconnecting from power supply.

2.Wipe with a soft, dry cloth. Use lukewarm water (below 40°C/104°F) and a soft, damp cloth to clean the appliance if it is very dirty.

3.Never use volatile substances such as gasoline or polishing powder to clean the appliance.

4.Never sprinkle water onto the main unit. It is dangerous and electric shock may result.

SPECIFICATIONS

Figures noted, in the contents are for reference only; variations may result due to application in different countries or regions, and shall be based on the best of practical operation.

Page 7
Image 7
Honeywell AMH-10000E, AMH-12000E manual Troubleshooting, Condition Of Purchase, Maintenance, Specifications, English