11.Have another person hold the Upright (4) near the front of the Frame (1). Locate the wire tie (see the inset drawing) in the Upright. Tie the lower end of the wire tie to the Wire Harness (28). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie.
Attach the Upright (4) to the Frame (1) with three
M8 x 15mm Screws (42). Be careful to avoid pinch- ing the Wire Harness (28).
12.The Console (6) requires four “D” batteries (not includ-
ed); alkaline batteries are recommended. Press the tab on the battery cover and remove it. Insert four bat- teries into the Console as shown. Make sure that the batteries are oriented as shown by the markings on the battery cover. Then, reattach the battery cover.
13.While another person holds the Console (6) near the Upright (4), connect the console wire harness to the Wire Harness (28). Insert the excess console wire har- ness into the Upright.
Attach the Console (6) to the Upright (4) with four M4 x 16mm Screws (64).
11
Avoid pinching the | 28 | |
Wire Harness (28) | ||
| ||
during this step | 4 | |
| ||
42 | 42 | |
| 1 | |
| Wire Tie | |
| 28 |
12
6
Batteries 
| Battery Cover |
13 |
|
64 | Console |
| Wire |
Harness
64 
4 
28
6
8
