17.Lubricate both axles on the Top Frame (1).
Identify the Right Arm (80) and the Left Arm (81) by noting the position of the welded bracket (A) on each Arm. Arm identification is very important for this step.
Place a Weld Cover (63) on top of the Right Butterfly Arm (80) in the location shown. Slide the Right Butterfly Arm onto the right axle. Note: Be careful not to confuse the Right and Left Arm.
Make sure the upper end of the Right Arm is behind the indicated bracket (B) on the Top Frame.
Tap a 3/4Ó Retaining Ring (86) and a 3/4Ó Dome Cap (75) onto the right axle. To do this, place the Retaining Ring on top of the inverted Dome Cap and tap the Cap onto the axle with a rubber mallet.
Make sure the teeth on the Retaining Ring (86) bend toward the Dome Cap (75), as shown in the inset drawing.
Attach the Left Butterfly Arm (81) in the same man- ner.
Cable Assembly
18.Locate and open the parts bag labeled ÒCable Assembly and Pulleys.Ó For Cable identification and routing during steps 18Ñ36, refer to the Cable Diagram and Cable ID Chart on page 19.
Identify the High Cable (73). It is approximately 163Ó long and it has a ball on one end and a bolt on the other.
Wrap the end of the High Cable (73) with the ball around a 3 1/2Ó Pulley (35). Attach the 3 1/2Ó Pulley to the indicated hole on the Top Frame (1) with a 3/8Ó x 3 1/2Ó Bolt (54), two 3/8Ó Flat Washers (55) and a 3/8Ó Nylon Jamnut (78).
Make sure the High Cable (73) is between the
3 1/2Ó Pulley (35) and the welded pin (not visible in the drawing) on the Top Frame (1).
17 | 1 | Lubricate | |
| B |
| A |
|
|
| |
|
|
| 63 |
| A |
| 81 |
Lubricate |
| 86 | |
|
|
| |
|
|
| 75 |
|
| 80 |
|
|
|
| Axle |
|
|
| 86 |
|
|
| 75 |
18 |
|
|
|
Welded Pin | 73 | 35 | |
| |||
|
|
| 54 |
| 1 |
| 55 |
|
|
| |
| 55 |
|
|
| 78 |
|
|
10
