35.Attach the closed loop at the end of the Low Cable (72) to the Support Bracket (27) on the Butterfly Upright (2) with a 5/16Ó x 1Ó Bolt (48) and a 5/16Ó Nylon Locknut (68).
Note: On the closed loop, the Cable is attached on one side, while the other side is flat (see the inset drawing). Make sure the flat side of the closed loop is facing the Support Bracket.
36.Important: Follow all three Cables from end to end and make sure they rest in the grooves of all Pulleys and that both the Cables and the Pulleys move smoothly.
Unscrew the cable bolt at the end of the High Cable (73) from the Weight Tube (77).
Thread the 1/2Ó Plain Nut (40) partway onto the cable bolt.
Slide a 1 1/2Ó Flat Washer (100) onto the cable bolt.
Tighten the cable bolt into the threaded hole in the Weight Tube (77). Note: The cable bolt is the pri- mary means for tightening the three Cables (72, 73, 97). Thread the bolt into the Weight Tube until all Cables are tight and rest firmly in the grooves of all Pulleys. See page 23 for further information on tightening the Cables.
When all Cables (72, 73, 97) are tight, tighten the 1/2Ó Plain Nut (40) onto the 1 1/2Ó Flat Washer (100) on top of the Weight Tube (77).
Insert the Weight Pin (39) into one of the holes between the Weights (26).
Seat Assembly
37.Locate and open the parts bag labeled ÒSeat Assembly.Ó
Attach one Seat (13) to the brackets on the Butterfly Seat Frame (11) with four 1/4Ó x 3/4Ó Screws (17).
35 | 2 |
| 72 |
| 48 |
| 27 |
| Cable on This Side |
| 68 |
| Flat Side of Loop |
36 |
|
| 73 |
| Cable Bolt |
| 40 |
| 100 |
| 77 |
39 |
|
| 26 |
37 | 13 |
| 11 |
| 17 |
| 17 |
15
