31.Wrap the Low Cable (72) around a 3 1/2Ó Pulley (35) in the direction shown. Slide the Pulley and a Cable Trap (44) onto a 3/8Ó x 4 3/4Ó Bolt (65). Slide the Bolt into the indicated hole in the bracket on the Butterfly Upright (2). Thread a 3/8Ó Nylon Locknut (50) a cou- ple of turns onto the Bolt to prevent it from sliding out during the following steps.
32.Wrap the Low Cable (72) around a 3 1/2Ó Pulley (35) in the direction shown.
Attach the Pulley (35) and a Cable Trap (44) to the lowest of the two holes in the Pulley Plates (31) hang- ing from the High Cable (73). Secure the Pulley and Cable Trap with a 3/8Ó x 2Ó Bolt (62) and a 3/8Ó Nylon Locknut (50).
Make sure the Cable Trap is oriented as shown and that it is mounted between the Pulley Plates.
33.Remove the 3/8Ó Nylon Locknut (50) that was thread- ed onto the 3/8Ó x 4 3/4Ó Bolt (65) in step 31.
Wrap the Low Cable (72) around a 3 1/2Ó Pulley (35) in the direction shown. Slide the Pulley and a Cable Trap (44) onto the 3/8Ó x 4 3/4Ó Bolt (65). Secure the Pulley with a 3/8Ó Nylon Locknut (50).
Make sure both Cable Traps attached to the 3/8Ó x 4 3/4Ó Bolt (65) are oriented as shown in this step and in step 31.
34.Wrap the Low Cable (72) around a 3 1/2Ó Pulley (35) in the direction shown. Attach the Pulley and a Cable Trap (44) to the
Make sure the Cable Trap is oriented as shown and that it is mounted between the Pulley Plates.
14
31 |
|
| 72 |
|
|
| 65 |
|
|
| 35 |
| 50 |
| 44 |
|
|
| |
|
|
| 2 |
32 |
|
| 73 |
| 31 |
|
|
| 50 |
|
|
| 44 |
| 62 |
|
| 35 | |
|
|
| |
| 72 |
|
|
33 | 72 |
| 2 |
|
| ||
|
|
| |
50 |
|
| |
| 35 | 44 | 65 |
34 |
|
| 97 |
|
|
| |
| 50 |
| 31 |
|
| 62 | |
|
|
| |
| 44 |
| 35 |
|
|
| |
|
|
| 72 |
