Assembly
Note: This introduction will save you more time than it takes to read it!
Making Things Easier for Yourself
Everything in this manual is designed to ensure that the assembly of our products can be complet- ed successfully by anyone. However, it is impor- tant to recognize that your new equipment is a sophisticated product with many small parts. The assembly process will take timeÑpossibly several hours. Most people find that by setting aside plen- ty of time, and by deciding to make the task enjoyable, assembly will go smoothly. You may want to complete the process over a couple of evenings.
Giving Yourself a Good Start
Before you begin the assembly process itself, take the time to complete the steps outlined here.
Clearing the Workspace
Clear a workspace that is large enough to hold all parts and allow you to walk all the way around the assembled equipment.
Unpacking the Box
To make the assembly process as smooth as possi- ble, we have broken it into separate stages. All parts used in each stage are found in individual packages in the shipping box. Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Important: Wait until you begin each assembly stage to open the parts bag labeled for that assembly stage.
Identifying Parts
To help you identify the small parts used in assem- bly, we have included a PART IDENTIFICATION CHART located in the center of this manual. Place the chart on the floor or work table and use it to quickly identify different parts as you open the pack- ages for each step.
Note: Some small parts may have been
Orienting Parts
As you assemble this product, be sure that all parts are oriented as shown in the drawings.
Tightening of Parts
Tighten all parts as you assemble them, unless instructed to do otherwise.
Lining Up the Tools
Assembly requires the following tools (not included):
¥ Two (2) adjustable wrenches
¥ One (1) standard screwdriver
¥ One (1) phillips screwdriver
¥ One (1) rubber mallet
¥Lubricant, such as grease or petroleum jelly, and soapy water
¥Tape, such as clear tape or masking tape
Assembly will be more convenient if you have a socket set, a set of
The Four Stages of the Assembly Process
Frame Assembly
You will begin by assembling the base and the upright frames that serve as the skeleton of the equipment. The seats and all moving parts will later be attached to the frame.
Cable Assembly
Completes the cables and pulleys that connect the moving arms with each other and with the weights. This ties the different parts together and makes the equipment function as a unit.
Arm Assembly
Completes the press and butterfly arms that you operate while you are exercising.
Seat Assembly
Completes the seats and backrests that support your body while you are exercising.
4
