7.Position two Weight Bumpers (19) over the indicated holes in the Stabilizer (5).
Insert both Weight Guides (23) through the Weight Bumpers (19) and the holes in the Stabilizer (5).
See the inset drawing. Press two Round Weight Inserts (76) into the indicated holes in each Weight (26). Make sure the large pin groove is pointed downward, as shown.
Slide all of the included Weights (26) onto the two Weight Guides (23). Make sure the Weights are ori- ented correctly. The holes must be turned towards the Press Upright (3), as shown.
8.Press the Weight Tube Bumper (64) into the end of the Weight Tube (77).
Lubricate the insides of the holes in the Top Weight (16).
Slide the Weight Tube (77) with the
9.Press a 2Ó Square Inner Cap (24) into each end of the crossbar on the Top Frame (1).
Place the Top Frame (1) on top of the two Uprights (2) and (3) in the direction shown. Align the holes in the Top Frame with the holes in the brackets on the Uprights.
Insert two 5/16Ó x 2 1/2Ó Bolts (45) with two 5/16Ó Flat Washers (53) through the holes in the Top Frame (1) and the bracket on the Butterfly Upright (2). Hand tighten a 5/16Ó Nylon Locknut (68) unto each Bolt. Do not tighten the Nylon Locknuts yet.
Insert two 5/16Ó x 2 3/4Ó Bolts (60) through the holes in the Support Plate (52), through the Top Frame (1) and the bracket on the Press Upright (3). Hand tight- en a 5/16Ó Nylon Locknut (68) unto each Bolt. Do not tighten the Nylon Locknuts yet.
7
7 |
| 76 |
23 |
|
|
|
| 26 |
3 |
|
|
| Large Pin |
|
| Groove |
|
Holes on |
|
|
this side |
|
|
| 26 |
|
19 |
|
|
5 |
|
|
8 |
| 16 |
23 |
| |
|
| |
|
| 77 |
|
| 64 |
|
| 26 |
9 | 60 | 45 |
1 |
|
|
52 |
| 53 |
| 24 | |
| 24 |
|
68 |
| 2 |
|
| |
|
| 68 |
3 |
|
|
