Remove the four #8 x 3/4" Screws (14), and care- fully remove the Motor Hood (61).
61 | 14 |
| 14 |
Locate the Reed Switch (44) and the Magnet (43) on the left side of the Pulley (42). Turn the Pulley until the Magnet is aligned with the Reed Switch.
Make sure that the gap between the Magnet and the Reed Switch is about 1/8 in. (3 mm). If necessary, move the Reed Switch slightly using a slotted screwdriver. Then, reattach the Motor Hood (not shown) with the four #8 x 3/4" Screws (not shown) and the two #8 x 1 1/2" Screws (not shown). Run the treadmill for a few minutes to check for a correct speed reading.
1/8 in. | 43 |
44 | |
Top | 42 |
View |
|
SYMPTOM: The incline of the treadmill does not change correctly
a.Calibrate the incline system (see step 3 on page 24).
SYMPTOM: The iFit Live mode is not functioning correctly
a.If the iFit Live mode is not functioning correctly, make sure that the treadmill has the most current firmware available (see step 7 on page 24).
SYMPTOM: The walking belt slows when walked on
a.Use only a
b.If the walking belt is overtightened, treadmill perfor- mance may decrease and the walking belt may be- come damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller screws counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walk- ing belt is properly tightened.
b
Idler Roller Screws
c.Your treadmill features a walking belt coated with
d.If the walking belt still slows when walked on, see the front cover of this manual.
27