Manuals / Promise Technology / Computer Equipment / Network Card

Promise Technology VTM210 Connecting the Power, VTrak front panel LED display. The M610i is shown

Models: VTM610i VTM210 VTM310i

1 34

Download 34 pages 32.63 Kb

Page 16

VTrak M610i, M310i, M210i Quick Start Guide

Step 6: Connecting the Power

Plug the power cords and switch on both power supplies on. When the power is switched on, the LEDs on the front of the VTrak will light up.

When boot-up is finished and the VTrak is functioning normally:

•Controller Heartbeat LED blinks green seven times in three seconds, goes dark for six seconds, then repeats the blink pattern.

•Power, FRU, and Logical Drive Status LEDs display green continuously.

•RAID Controller LED flashes green if there is activity on a iSCSI port.

Figure 17.VTrak front panel LED display. The M610i is shown

Power

FRU Status

Logical Drive Status

RAID Controller Activity

Reserved

Controller Heartbeat

There are two LEDs on each Drive Carrier. They report the presence of power and a disk drive, and the current condition of the drive.

Figure 18.VTrak disk carrier LEDs

Disk Status

Power/Activity

After a few moments the Power/Activity should display Green.

16

Image 16

Promise Technology VTM210, VTM610i, VTM310i Connecting the Power, VTrak front panel LED display. The M610i is shown

Contents

Vtrak VTrak Installation Task List Unpacking the VTrakVTrak M610i front view VTrak M610i rear view Mounting VTrak in a Rack Mounting the VTrak M610i in a RackRack mount assembly diagram Mounting VTrak M310i or M210i in a Rack Rackmounted VTrak M310i M210i is similarSliding flange installation Mounting rail installation Drive Slot Numbering Installing Disk DrivesLevel Number of Drives Installing Disk Drives VTrak drive carrier mounting holes Configuring an IP Storage Area Network Making Management and Data ConnectionsData Path Management PathConfiguring Direct Attached Storage VTrak DAS connectionsMaking Serial Cable Connections Connecting the Power VTrak front panel LED display. The M610i is shownConnecting the Power Setting the IP Address Viewing MAC and IP Addresses in the CLI Choosing Dhcp or a Static IP AddressViewing MAC and IP Addresses in the CLU Administrator@cli net -a mod -t mgmt -s dhcp=enable Setting up VTrak with the CLIAdministrator@cli net -a mod -t iSCSI -p 1 -s dhcp=enable 192.168.10.1 ISCSI Setting up VTrak with the CLU Setting system date and timeMaking Management Port settings Manual IP settingsAutomatic IP settings Viewing IP address and settingsExiting the CLU Creating Disk Arrays with WebPAM PROe Logging into WebPAM PROeRegular Connection Secure ConnectionWebPAM PROe log-in screen Selecting a Language Creating a Disk ArrayAutomatic Express Disk Array Creation AdvancedLogical Drive Creation Logging out of WebPAM PROe Using WebPAM PROe over the InternetSummary Technical Support Services Contacting Technical SupportUnited States NetherlandsItaly GermanyTaiwan China Obtaining a Security CertificateVTrak M610i, M310i, M210i Quick Start Guide