Step 2: Mounting VTrak in a Rack
Mounting VTrak M310i or M210i in a Rack
The VTrak M310i or M210i subsystem installs to the rack using the supplied mounting rails. You can also use your existing rails.
Figure 7. Rackmounted VTrak M310i (M210i is similar)
Vertical Rack Post | VTrak M310i/M210i | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Handles mount | Mounting rails (included) |
outside the rack post | mount inside the rack post |
Cautions
•At least two persons are required to safely lift, place, and attach the VTrak subsystem into a rack system.
•Do not lift or move the VTrak subsystem by the handles, power supplies or the controller units. Hold the subsystem itself.
•Do not install the VTrak subsystem into a rack without rails to support the subsystem.
•Only a qualified electrician who is familiar with the installation procedure should mount and install the VTrak subsystem.
•Be sure all switches are OFF before installing the VTrak subsystem or exchanging components.
To install the M310i or M210i subsystem into a rack with the supplied mounting rails:
1.Check the fit of the mounting rails in your rack system. See Figure 9.
2.Slide the plates out of the mounting rails.
3.Attach one plate to each side of the VTrak subsystem.
7
