Before Use
Read this before operation
•As the unit may become warm during operation, always leave sufficient space around the unit for ventilation.
The ventilation holes should not be covered. Make sure there is at least 50 cm of space above and at least 10 cm of space on each side of the unit. Do NOT place anything on top of the unit.
•The voltage supplied to the unit should match the voltage as printed on the rear panel. If you are in any doubt regarding this matter, consult an electrician.
•Choose the installation location of your unit carefully. Avoid placing it in direct sunlight or close to a source of heat. Also avoid locations subject to vibrations and excessive dust, heat, cold or moisture.
•Do not place the unit on the amplifier/receiver.
•Do not open the cabinet as this might result in damage to the circuitry or electrical shock. If a foreign object should get into the unit, contact your dealer or service company.
•When removing the power plug from the wall outlet, always pull directly on the plug, never yank the cord.
•Do not attempt to clean the unit with chemical solvents as this might damage the finish. Use a clean, dry or slightly damp cloth.
•Keep this manual in a safe place for future reference.
How to Reset the Settings to the FACTORY DEFAULTS
Memory Backup
If the power supply is interrupted for 14 days or longer, the settings kept in memory (such as preset stations and speaker settings) will be erased.
Restoring factory settings
If you have made a lot of changes to the setup, and want to restart from a known set of options, restore the unit to the factory settings as follows:
1.With the unit in the standby mode, briefly press the STANDBY/ON switch while holding down the MEMORY/ENTER button.
•Release the MEMORY/ENTER button immediately after pressing the STANDBY/ON switch.
The model name, etc. appears on the display.
2.Press the MEMORY/ENTER button. The unit turns standby.
3.Press the POWER switch to turn the unit off.
All memories are erased, and the unit returns to the factory settings.
3
