COMPUTER MODE
AUTOMATIC
This projector automatically tunes to most different types of computers based on VGA, SVGA, XGA or SXGA (refer to “COMPATIBLE COMPUTER SPECIFICATION” on page 29). When selecting Computer, this projector automatically tunes to the incoming signal and projects the proper image without any special settings. (Setting of the Computer System may be required when connecting some computers.)
Note : The projector may display one of the following messages.
Go to PC adj. |
| The projector cannot discriminate or detect the input |
|
| signal from the computer. Adjust and set the |
|
| |
|
| computer system manually. |
|
|
|
|
|
|
No signal |
| There is no signal input from the computer. Make |
|
| sure the connection of the computer and the |
|
| |
|
| projector is set correctly. |
|
|
|
The input signal is digital from the DVI terminal.
CURRENT MODE DISPLAY
The Current Mode display appears to show the information of the computer being selected.
SYSTEM BOX
Display the SYSTEM being selected.
SYSTEM
Analog |
| XGA 1 |
When select the DVI terminal.
|
|
|
|
|
|
|
| SYSTEM |
|
| RGB |
| XGA 1 |
|
|
|
|
|
|
When select the 5 BNC terminal.
4 | XGA 1 |
|
When select the HDB
Providing the information of the computer detected by the projector.
SELECT COMPUTER SYSTEM MANUALLY
To set the Computer system manually, select the mode on the
1 |
| Press the MENU button and the |
| appear. Press the POINT LEFT/RIGHT buttons to select | |
|
| SYSTEM and press the SELECT button. Another dialog box |
|
| |
|
| COMPUTER SYSTEM Menu will appear. |
2 |
|
|
| Press the POINT DOWN button and a | |
| appear. Move the arrow to the system that you want to set, and |
then press SELECT button.
The systems on this dialog box can be selected.
When this mark is displayed as black, more computer system modes will be available. Move the arrow to this mark and then press the SELECT button, and the other modes will be displayed.
Close the SYSTEM Menu.
28