APPENDIX

LAMP REPLACEMENT

CAUTION

● For continued safety, replace with a lamp assembly of the same type.

●Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot.

●Do not drop the lamp assembly or touch the glass bulb! The glass can shatter and may cause injury.

Follow these steps to replace the lamp assembly.

1

 

Check the number of lamp to be replaced on Lamp Status

 

 

 

 

Display.

 

 

 

 

 

 

 

 

 

2

 

Turn off the projector and disconnect the AC Power Cord. Allow

 

the projector to cool down for at least 45 minutes.

 

 

 

 

 

 

3

 

 

Remove the two screws on the Lamp Cover and press the

 

 

 

 

 

 

 

 

button to open the Lamp Cover. (See right figure.)

 

 

 

 

 

 

 

 

 

 

 

4

 

 

Loosen the two screws and pull out the Lamp Assembly to be

 

 

 

 

 

 

 

 

replaced by grasping the handle.

 

 

 

 

 

 

 

 

 

 

 

BUTTON

LAMP

COVER SCREWS

SCREWS

5

 

 

 

 

Replace the Lamp Assembly with a new one and tighten the two

 

 

 

 

 

 

 

 

 

 

 

 

 

 

screws. Make sure the Lamp is set properly

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

6

 

 

 

 

 

 

 

 

 

Replace the Lamp Cover and tighten the two screws.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

7

 

 

 

 

Connect the AC Power Cord to the projector and turn the

 

 

 

 

 

projector on.

 

 

 

 

 

 

 

 

8

 

 

 

 

 

 

 

 

 

 

Reset the Lamp Replacement Monitor Timer. (Refer to the

 

 

 

 

 

 

section "Lamp Replacement Monitor Timer" on page 41.)

NOTE : Do not reset the LAMP REPLACEMENT MONITOR TIMER when the lamp is not replaced.

CAUTION : Do not operate the projector while any of lamps is removed. It may result in malfunctions, fire hazard, or other accidents.

LAMP 3

LAMP 1

LAMP 4

LAMP 2

Make sure which number of lamp needs to be replaced on Lamp Status Display.

Figure shows the case of replacing the LAMP 2.

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through your dealer. When ordering the Lamp, give the following information to the dealer.

● Model No. of your projector : Pro AV 9350

●Replacement Lamp Type No. : POA-LMP29 (Proxima Lamp No.: LAMP-XXX)

(Service Parts No. 610 284 4627)

CLEANING THE PROJECTION LENS

Follow these steps to clean the projection lens:

1

 

Apply a non-abrasive camera lens cleaner to a soft, dry cleaning cloth. Avoid using an excessive amount of cleaner.

 

Abrasive cleaners, solvents or other harsh chemicals might scratch the lens.

2

3

Lightly wipe the cleaning cloth over the lens.

When the projector is not in use, replace the lens cover.

45