CONNECTING THE PROJECTOR
SERIAL PORT
IN TERMINAL
If you control the projector by computer, you must connect a cable (not provided) from your computer to this terminal.
USB PORT
This port is used to control the projector with the computer. It is also used to control the computer with the Remote Control of this projector. (Refer to P40, 42.)
Connect the USB port of the computer to this port.
SERIAL PORT
OUT TERMINAL
This terminal outputs the signal from SERIAL PORT IN. More than two projectors can be controlled with one computer by connecting SERIAL PORT IN. of another projector to this terminal.
serial port IN
serial port OUT
|
| DVI |
| audio |
| PC control |
|
|
| R | L | 1 | |
|
|
|
| |||
|
|
|
|
| (mono) | INPUT- |
|
|
|
|
|
| |
R/Pr | G/Y | B/Pb | H/HV | audio |
| PC control |
V | L | |||||
|
|
|
| R | ||
|
|
|
|
| (mono) | |
|
|
|
|
|
|
R/C jack | USB |
audio OUT
R 
L
reset
(mono)
R/C JACK
When using the Wired / Wireless Remote Control Unit as the Wired Remote Control, Connect the Wired Remote Control Unit to this jack with the Remote Control Cable (supplied). (Refer to page 19.)
video/Y | C | audio |
| 3 | |
| R | L | |||
|
|
| |||
|
|
| INPUT- | ||
|
|
|
| (mono) | |
|
|
|
|
| |
|
| analog RGB | audio | PC control |
|
|
| R | L | 4 | |
|
|
| |||
|
|
|
| (mono) | INPUT- |
|
|
|
|
|
RESET BUTTON
This projector uses a micro processor to control the unit. Occasionally, the micro processor may malfunction and need to be reset. This can be done by pressing the RESET button with a pen, which will shut down and restart the unit. Do not use the RESET function excessively.
AUDIO OUTPUT JACKS
Connect an external audio amplifier to these jacks.
(Refer to P14, 15.)
13