PSC 1400I manual Default Setting Suffix 0D CR

Global Pre-

fix/Suffix

Global Prefix/Suffix — cont.

START / END

PROGRAMMING BARCODES

Sets up to 20 characters each from the set of ASCII characters or any hex value from 0 to FF. To configure this feature, scan the “START/END” bar code above to place the unit in Programming Mode, then the “Set Prefix” or “Set Suffix,” followed by the digits from the Alphanumeric table in Appendix C, Alpha-Numeric Pad representing your desired character(s). Reference the section, "Example: Setting a Prefix", for more information. Exit programming mode by scanning the “START/END” barcode again (scan “START/END” twice if less than 20 characters have been selected).

DEFAULT SETTING PREFIX: 00 (None)

DEFAULT SETTING SUFFIX: 0D (CR)

Set Prefix

Set Suffix

Product Reference Guide 4-3