Quadra-Fire 7008-115 Gas Information, A. Fuel Conversion, B.Converting to LP Gas, Screws

9 Gas Information

A. Fuel Conversion

•Make sure the appliance is compatible with available gas types.

•Conversions must be made by a qualified technician (NFI certified or factory-trained) using Hearth & Home Technologies specified and approved parts.

B.Converting to LP Gas

Note: Gas conversions should only be performed by a qualified service person, and/or where required by state and local codes, licensed installer/service technician. In the Commonwealth of Massachusetts, installation must be performed by a licensed plumber or gas fitter.

Lift the burner up and out of the firebox opening.

Figure 9.2

Kit contents: Replacement orifice; replacement pilot injector; valve regulator; conversion label.

Tools required: Ratchet with 7/16 in. (11 mm) socket

and 2 in. - 4 in. (51-102 mm) extension: power drill (a 90° handle is helpful); #2 Phillips bit; 5/32 in. (4 mm) Allen wrench; 5/8 in. (16 mm) open end wrench.

Remove right and left twigs and right and left rear logs from the burner pan, if installed. Remove the two nuts that secure the burner pan to the burner support with the ratchet and socket.

Remove the three screws on the front of the burner sup- port. Set screws aside.

3 SCREWS

2 NUTS HOLDING

BURNER PAN

Figure 9.3

Slide the burner support to the left to access the orifice.

BURNER SUPPORT SCREWS

Figure 9.1

Figure 9.4

22 Quadra-Fire • HUDBAY-INS • 7008-115 Rev. o • 8/11