F. Grille Installation
Remove the door of appliance. Remove the four screws (two at each end) holding grille in place. Lift up to remove.
Assemble the trim with the two corner brackets provided. Slide the assembled trim over the assembled panel set.
Figure 12.5
Install the new grille by reversing removal instructions.
Note: Clean glass and gold or nickel with glass cleaner and a soft cloth, wiping off all fingerprints prior to first fire to prevent permanent staining.
G. Panel Set Installation
Included in kit: (2) Angle Brackets and set screws; (1) 3 piece Trim; (2) Side Panels; (1) Top Panel; (1) Switch plug; and (8) screws.
Tools required: Philips head screwdriver.
Note: Remove the door from the insert before beginning the panel installation.
Assemble the panel top to the panel sides with the screws provided.
BACK OF TOP PANEL
SCREWS
BACK OF SIDE PANEL
Figure 12.6
Figure 12.7
Slide the panel/trim down over the face of the unit, behind the top, aligning the holes in the upper and lower, right and left corners, and secure the panel and trim set to the appliance with the attachment screws using four screws, two per side.
SCREWS
Figure 12.8
Determine your desired placement of the rocker switch.
1If you wish to place it on the control panel in the "Main Burner" opening: Disconnect the "ON/OFF" switch from the low voltage wire leads. Pull the wires through the control panel, attach the wires to the "ON/OFF" rocker switch and push the rocker switch into the "Main Burner opening on control panel. Place the plug provided in empty opening on the panel and trim.
OR
2.If you wish to place it on the side of appliance in the knock out provided on the panel and trim: Carefully reposition the wiring beneath the firebox to the RIGHT side of appliance. Disconnect the "ON/OFF" switch from the low voltage wire leads. Pull the wires through the knockout plate on the panel and trim, attach the wires to the "ON/OFF" rocker switch and push the rocker switch into the opening on the panel and trim. Place plug provided with panel set in empty switch location.
Install the power cord restraint found in the appliance com- ponent bag. (Cord is shipped exiting the right side of the appliance, but can be routed in either direction.) A notch will be needed in the trim piece for the cord restraint.
Slide the appliance back until the panel is tight to the fireplace.
30 |
