Quadra-Fire 7008-115 Appliance Setup, A. Remove Glass Assembly, B. Remove the Shipping Materials

12 Appliance Setup

A. Remove Glass Assembly	Uninstall the existing crown by removing the four screws
See Section 12.L.	on the back side of the door. Retain the screws.

B. Remove the Shipping Materials

Remove shipping materials from inside or underneath the firebox.

C. Clean the Appliance

Clean/vacuum any sawdust that may have accumulated inside the firebox or underneath in the control cavity.

D. Accessories

Install approved accessories per instructions included with accessories. Contact your dealer for a list of ap- proved accessories.

WARNING! Risk of Fire and Electric Shock! Use ONLY Hearth & Home Technologies-approved optional acces- sories with this appliance. Using non-listed accessories could result in a safety hazard and will void the warranty.

E. Door Crown Installation

Open lower access panel. Pull out and unhook the two spring latches on the bottom of the appliance that secure the door.

Rotate the door forward approximately 1-1/2 in. (38 mm). Holding the ashlip, lift the door up off of the stationary latches and away from the appliance.

Figure 12.2

Use a flat-head screwdriver to pry the black crown free on the right side. Remove the crown and discard.

STATIONARY LATCHES

SPRING LOADED LATCHES

Figure 12.1

Figure 12.3

Carefully align the left side of the crown into place, and wrap it across the face of door, finally snapping it into place on the right hand side. Reinsert and tighten the screws previously removed.

Figure 12.4

Note: Use a soft cloth and a window cleaning solution to clean all fingerprint oils from the gold or nickel surface of crown PRIOR to lighting the appliance.

Quadra-Fire • HUDBAY-INS • 7008-115 Rev. o • 8/11 29