CUT AND BEND
FLASHING AS NEEDED
TO FIT CHIMNEY
SEALANT
ADHESIVE
Figure 8.2
•Trim chimney top plate to minimize excess overhang or bend over flue tile (see Figure 8.2).
•Place 3/8 inch bead of silicone (minimum of 300ºF continuous exposure rating) on flue tile top.
D.Placing, Securing and Leveling the Appli- ance
•Attach surround. Follow instructions accompanying surround.
•Install insert (with surround attached) into existing fireplace while pulling transition assembly forward.
•Attach Transition Assembly to the appliance. Rotate Transition Assembly latches and lock with 7/16 inch wrench.
•Install gas line into hole provided on insert side.
•If applicable install remote control wires into insert side (see Section 8.E.).
•Level the appliance from side to side and front to back. If necessary, attach the shipping brackets that were used to attach the unit to the pallet, to the rear of the appliance for use as levelling legs.
•Position any excess flexible vent pipe back up into chimney without sagging. Twist and push flex vent together to shorten.
•Install fiberglass insulation pieces to back face of surround.
•Push insert so that surround becomes tight against face of fireplace.
WARNING! Risk of Fire! Only an approved Hearth & Home Technologies surround may be used to cover inte- gral grills on solid fuel burning fireplaces. No other com- ponents such as shrouds, sheetmetal plates, etc., may be used to seal off vents.
WARNING! Risk of Explosion! Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this appliance may result in property damage or personal injury.
WARNING! Risk of Explosion/Combustion Fumes! Connect vent sections per installation instructions.
•Connect exhaust vent pipe ONLY to exhaust starting collar and termination cap center collar.
•Connect inlet air vent ONLY to inlet air collar on appliance and either the termination cap inlet air collar OR terminate within chimney.
•DO NOT allow vent to sag below connection point to appliance.
TERMINATION CAP
ADAPTER
FLEX PIPE
TRANSITION ASSEMBLY
SHIPPING BRACKETS ATTACHED
TO REAR OF APPLIANCE FOR
USE AS LEVELING LEGS
Figure 8.3
E. Remote Control
The receiver for the remotes must be installed BETWEEN the base pan of the insert and the firebox of the wood- burning fireplace (see photo below).
EXISTING SIDE
REFRACTORY
REMOTE
RECEIVER
UNIT
EXISTING BOTTOM OF
FIREPLACE
Figure 8.4
20 |