I. Brick Installation
The pilot shield has to be removed to install or remove the brick refractory. Removal of the bracket requires remov- ing two screws.
| PILOT |
PILOT | SHIELD |
| |
BRACKET |
|
Figure 12.10 |
|
To install the baffle, slide it in at an angle and rotate upward, parallel with the firebox. Place baffle up against the heat exchangers in top of the firebox. Holding the baffle against the heat exchangers, slide the baffle towards the front of the appliance.
Note: To aid in brick installation, the burner may be removed.
Figure 12.11
Keeping the baffle elevated with your free hand, put the right side brick into position. Rest the baffle on the right side brick.
Still holding the baffle in place, install the left brick into position.
Figure 12.13
Bend retaining tabs on the left and right sides inward to hold brick in place.
RETAINING TABS
Figure 12.14
Install the rear brick. Slide it in at an angle and place it over the rear brick retainer. Hand bend retaining tabs up to hold brick in place. Slide baffle back until touching rear brick.
Figure 12.12
Figure 12.15
32 |
