6 Gas Information
A. Fuel Conversions
Before making gas connections ensure that the appliance being installed is compatible with the available gas type.
Any natural or propane gas conversions necessary to meet the appliance and locality needs must be made by a quali- fied technician using Hearth & Home Technologies specified and approved parts.
1. Converting to LP Gas
NOTE: Gas conversions should only be performed by a qualified service person, and/or where required by state and local codes, licensed installer/service technician. In the Commonwealth of Massachusetts, installation must be performed by a licensed plumber or gas fitter.
KIT CONTENTS: Replacement orifice; replacement pilot injector; and valve regulator.
TOOLS REQUIRED: Power drill (a 90° handle is helpful); #2 Phillips bit; 5/32 in. Allen wrench; 5/8 in. open end wrench.
3 screws
Figure 6.3 Remove the three screws on the front of the burner support. Set screws aside.
Opens Left | Closes Right |
Figure 6.4 Slide the burner suport to the left to access the orifice.
Figure 6.1 Disconnect power and turn off gas supply if installed. Remove front, glass, and logs if installed. Loosen the shutter adjustment nut (located underneath the appli- ance) with a 7/16 in. wrench. Slide the shutter to the left (open position).
Burner Screws
Figure 6.5 Remove the main burner orifice using a 5/8 in. wrench and replace the orifice with the proper size as indi- cated below for your gas type and venting.
Figure 6.2 Burner removal: Remove burner by first remov- ing the two screws indicated and lifting the burner out.
January 3, 2007 |
| Page 23 |
