IBM 8682 manual Error Code/Symptom

Error Code/Symptom	FRU/Action
1301	1.	Cable
(cable to front panel not found)	2.	Front Panel
	3.	Power Switch Assembly
	4.	System Board
1302	1.	Cable
(cable from system board to power on and	2.	Power Switch Assembly
reset switches not found)	3.	System Board
1303	1.	Cable
(cable from system board to power	2.	Power Backplane
backplane not found)	3.	System Board
1304	1.	Cable
(cable to diagnostic LED board not found)	2.	Diagnostic LED Board
	3.	System Board
1600	1.	System Board
(Advanced System Manage-ment	2.	Service Processor Board
processor is not functioning) Do the
following before replacing a FRU:
1. Ensure that a jumper is not installed
on J5.
2. Remove the ac power to the system,
wait 20 seconds; then, re-connect the
ac power. Wait 30 seconds; then,
power-on the system.
1601	1.	System Board
(The system is able to communicate to the	2.	Service Processor Board
Service Processor, but the Service
Processor failed to respond at the start of
POST.)
Do the following before replacing a FRU:
1. Remove the ac power to the system,
wait 20 seconds; then, re-connect the
ac power. Wait 30 seconds; then,
power-on the system.
2. Flash update the Service Processor.
1800	1.	Run Configuration/Setup
(No more hardware interrupt available for	2.	Failing Adapter
PCI adapter)	3.	System Board
1962	1. Verify a bootable operating system is installed.
(Drive does not contain a valid boot	2. If RAID system, refer to the Hardware Maintenance Manual for the
		specific RAID adapter.
sector)
	3.	Run Diagnostics
	4.	Hard Disk Drive
	5.	Cable
	6.	SCSI Backplane
	7.	System Board

Symptom-to-FRU index 113