IBM 8682 manual PCNTNW-NW-079

Table 3. Novell NetWare or IntraNetWare ODI driver messages for the Ethernet controller (continued)

PCNTNW-NW-079	The Multiple Link Interface Driver (MLID) did not initialize MSMTx Free Count.
	Explanation: The MSMTx Free Count is not initialized correctly.
	Action: Restart the server. If the problem persists, go to “Starting the diagnostic
	programs” on page 14 to run the diagnostic programs.
PCNTNW-NW-086	The driver parameter block is too small.
	Explanation: The driver parameter block is too small.
	Action: Restart the server. If the problem persists, go to “Starting the diagnostic
	programs” on page 14 to run the diagnostic programs.
PCNTNW-NW-087	The media parameter block is too small.
	Explanation: The driver media parameter block is too small.
	Action: Restart the server. If the problem persists, go to “Starting the diagnostic
	programs” on page 14 to run the diagnostic programs.
PCNTNW-NW-091	The hardware configuration conflicts.
	Explanation: You tried to load a new frame type for the existing controller. The
	hardware assumptions made in doing so are incorrect. This error can also occur if
	you try to specify a mode (such as, redundancy) that conflicts with another specified
	mode.
	Action: Make sure that the hardware configuration matches the software settings.
PCNTNW-NW-126	The group bit in the node address override was cleared.
	Explanation: The IEEE address has a group bit that indicates that an address
	belongs to a group of stations. This bit is used only as a destination address; it
	cannot be used as a source address. You tried to enter a source address with this bit
	set. The driver cleared the group bit of the source address.
	Action: None necessary, message is for information only.
PCNTNW-NW-127	The local bit in the node address override was set.
	Explanation: The local bit in the IEEE address format indicates that the addresses
	are being managed locally. If you use the node address override capabilities of this
	driver to enter a new address, the local bit must be set. You entered an address
	without the local bit set. The driver has set the local bit.
	Action: None necessary, message is for information only.
PCNTNW-NW-164	The device was not found.
	Explanation: The driver cannot find an Ethernet controller in the server.
	Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is
	enabled, go to “Starting the diagnostic programs” on page 14 to run the diagnostic
	programs.
PCNTNW-NW-165	The device was not found at IOADDRESS.
	Explanation: The Ethernet controller cannot be found at the I/O address specified.
	Action: The Ethernet controller does not require a parameter for the I/O address.
	Remove the I/O address parameter.
PCNTNW-NW-167	PCI scan specified, device not found.
	Explanation: The driver cannot locate the Ethernet controller on the PCI bus.
	Action: Verify that the Ethernet controller is enabled. If the problem persists, go to
	“Starting the diagnostic programs” on page 14 to run the diagnostic programs.
PCNTNW-NW-180	The DMA parameter is not necessary for PCI device.
	Explanation: The Ethernet controller does not require a DMA setting.
	Action: None necessary, message is for information only.

Diagnostics 27