IBM 8682 manual Installing a hot-swap power supply, Filler panel AC power light DC power light

Installing a hot-swap power supply

The following illustration shows how to install a hot-swap power supply.

Note: The illustrations in this document might differ slightly from your hardware.

Filler panel

AC power light

DC power light

Power supply Power supply handle

To install an additional power supply:

1.Remove the filler panel.

2.Place the handle on the power supply in the open position.

3.Slide the power supply into the chassis and close the handle.

4.Plug the power cord into the power supply; then, into a properly grounded electrical outlet.

5.Verify that the DC Power light and the AC Power light on the power supply are lit, indicating that the power supply is operating properly.

Statement 8

CAUTION:

Never remove the cover on a power supply or any part that has the following label attached.

Hazardous voltage, current, and energy levels are present inside any component that has this label attached. There are no serviceable parts inside these components. If you suspect a problem with one of these parts, contact a service technician.

70IBM xSeries 350 Type 8682: Hardware Maintenance Manual