IBM 8682 manual Replacing the battery

4.Insert the BIOS flash diskette into the diskette drive.

5.Restart the server.

6.The system begins the power-on self-test (POST). Select 1 – Update POST/BIOS from the menu that contains various flash (update) options.

7.When you are asked if you would like to move the current POST/BIOS image to the backup ROM location, type N.

Attention: Typing Y will copy the corrupted BIOS into the secondary page.

8.When you are asked if you would like to save the current code to a diskette, select N.

9.You will be asked to choose which language you wish to use. Select your language (0-7) and press Enter to accept your choice. You will be prompted to remove the diskette and press Enter to restart the system. Remove the flash diskette from the diskette drive.

Attention: Do not press Enter to reboot the system at this time.

10.Power-off the server.

11.Move jumper J14 back to pins 2 and 3 to return to normal startup mode.

12.Restart the server. The system should start up normally.

Replacing the battery

The following notes describe information that you must consider when replacing the battery in the server.

vWhen replacing the battery, you must replace it with a lithium battery of the same type from the same manufacturer.

vTo order replacement batteries, call 1-800-772-2227 within the United States, and 1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada, call your IBM reseller or IBM marketing representative.

vAfter you replace the battery, you must reconfigure the system and reset the system date and time.

vTo avoid possible danger, read and follow the following safety statement.

Statement 2

CAUTION:

When replacing the lithium battery, use only IBM Part Number 33F8354 or an equivalent type battery recommended by the manufacturer. If your system has a module containing a lithium battery, replace it only with the same module type made by the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or disposed of.

Do not:

vThrow or immerse into water

vHeat to more than 100°C (212°F)

vRepair or disassemble

Dispose of the battery as required by local ordinances or regulations.

Complete the following steps to replace the battery:

1. Read the information in “Before you begin” on page 50

Diagnostics 21