IBM 8682 manual Diagnostic error codes, The Esc key was pressed to abort the test

Diagnostic error codes

Note: In the following error codes, if XXX is 000, 195, or 197 do not replace a

FRU. The description for these error codes are:

000The test passed.

195The Esc key was pressed to abort the test.

197This is a warning error and may not indicate a hardware failure. For all error codes, replace/follow the FRU/Action indicated.

Error Code/Symptom	FRU/Action
001-XXX-000	1.	System Board
(Failed core tests)
001-XXX-001	1.	System Board
(Failed core tests)
001-250-000	1.	System Board
(Failed System Board ECC)
001-250-001	1.	System Board
(Failed System Board ECC)
005-XXX-000	1. Video Adapter (if installed)
(Failed Video test)	2.	System Board
011-XXX-000	1.	System Board
(Failed COM1 Serial Port test)
011-XXX-001	1.	System Board
(Failed COM2 Serial Port test)
014-XXX-000	1.	System Board
(Failed Parallel Port test)
015-XXX-001	1.	System Board.
(Failed USB test)
015-XXX-015	1. Make sure parallel port is not disabled.
(Failed USB External Loopback test)	2. Re-run USB External Loopback test.
	3.	System board.
015-XXX-198	1. Remove USB devices from USB1 and USB2.
(USB device connected during USB test)	2. Re-run test.
	3.	System Board.
020-XXX-000	1.	System Board
(Failed PCI Interface test)
020-XXX-001	1. PCI Hot-Swap Latch Assembly
(Failed Hot-Swap Slot 1 PCI Latch test)	2.	System Board

Symptom-to-FRU index 103