IBM 8682 manual To cable the ServeRAID adapter 1. Turn off the server

To cable the ServeRAID adapter:

1.Turn off the server.

2.Remove all adapters from the Active PCI adapter slots.

3.Remove the plastic dividers between the PCI adapter slots.

4.Press the fan assembly release latches on both sides of the fan assembly; then, remove the fan assembly from the server.

Plastic dividers

ServeRAID adapter

Fan assembly release latch

5.Disconnect the internal SCSI cable from the SCSI connector (J38) on the system board. (See “System board cable connectors” on page 43).

6.Carefully thread the disconnected end of the internal SCSI cable out of the chassis, pulling the cable out of the opening in the chassis.

7.Reinstall the fan assembly in the server.

8.Replace the plastic dividers between the PCI adapter slots.

9.Reinstall the adapters in the PCI adapter slots.

10.The following illustration shows how to route the SCSI cable to the ServeRAID adapter.

Installing options 57