IBM 8682 manual Removing the server top cover and bezel

Removing the server top cover and bezel

Review the information in “Before you begin” on page 50

The following illustration shows how to remove the top cover and bezel from the server.

Note: The illustrations in this document might differ slightly from your hardware.

Top cover

Release latch

Cover release latch

Release latch

To remove the server top cover:

Bezel

1.Lift the plastic cover-release latch near the edge of the top cover.

2.Slide the top cover slightly toward the rear of the server; the cover will stop after about 25 mm (1 inch). Lift the cover off the server and set the cover aside.

Attention: For proper cooling and airflow, replace the top cover before turning on the server. Operating the server for extended periods of time (over 30 minutes) with the top cover removed might damage server components.

To remove the bezel:

1.Release the two tabs at the top edge of the bezel and pull the top of the bezel slightly away from the server.

2.Pull the bezel up to release the two tabs at the bottom edge of the bezel. Store the bezel in a safe place.

Installing options 53