Quadra-Fire QFP38-LP Appliance Setup, A. Remove Fixed Glass Assembly, C. Clean the Appliance

15 Appliance Setup

A. Remove Fixed Glass Assembly	• Install the upper back refractory.
See Section 15.K.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.

D. Install the Refractory

•Remove the refractory retainer from each side of the firebox.

•Put the left side refractory in place and reinstall the left side refractory retainer.

Refractory Retainer

Figure 15.1 Install Left Side Refractory

•Install the lower back refractory.

Figure 15.3 Install Upper Back Refractory

•Install the right side refractory.

Figure 15.4 Install Right Side Refractory

•Slide the back refractory slightly from side to side as necessary to close up any gaps in the corners.

•Install the right side refractory retainer.

Note: As you use the appliance, expansion and contraction will cause minor cracking of the refractory. This is normal, unavoidable, and will not affect the performance of the appliance. If the cracks become large enough that the metal behind the refractory is exposed or large pieces fall out, the panels should be replaced.

Figure 15.2 Install Lower Back Refractory

Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09 57