Quadra-Fire QFP38-LP, QFP38-NG owner manual B. Facing Template Removal, Doors - Outside Surface Fit

Doors - Outside Surface Fit

Sheetrock/wall finishing material will have been installed and the joints filled.

•Remove facing templates, retain screws for door installation.

•Non-combustible facing material less than one inch thick may be brought to the edge of the fireplace opening.

•Doors will be mounted over facing material.

•Door frame is slotted to allow the door to be mounted up to one inch from the surface of the fireplace.

Figure 14.3 Door Frame Flush to Bottom Edge of Fireplace

Doors - Recessed Fit

Sheetrock/wall finishing material will have been installed and the joints filled.

•Facing material must be butted to the flanges of the facing templates.

•Remove templates - retain screws for door installation.

B. Facing Template Removal

There is a metal template on each side and across the top of the door opening. See Figure 14.4.

•Side Templates

-Remove the screws from the sides of the door opening and set aside.

-Remove and discard the template pieces.

•Top Template

-Loosen the screws across the top of the opening.

-Slide the top template out and discard.

-Tighten the screws.

	Template
	Pieces
Figure 14.4	Facing Template

Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09 55