Quadra-Fire QFP38-LP, QFP38-NG H. Accent Lighting Set Up, Screws, Rubber band Light Box

H. Accent Lighting Set Up

•Remove the two screws (one on each side) holding the dashboard in place.

•Unplug the two brown wires from the back of the ON/OFF switch.

•Set the dashboard and two screws aside for later reinstallation.

Screws

Figure 15.20 Remove Dashboard

•Turn off the control module and/or unplug light cord (white) before moving on.

•Locate one of the two light boxes (one on each side behind dashboard). See Figure 15.21.

Rubber band

Light Box

Figure 15.21 Light Box

•Clip and discard the rubber band holding the light box in place.

Figure 15.22 Clip the Rubber Band

•Pull out the light box.

Pull light box out of housing

Figure 15.23 Pull Out Light Box

•Remove lightbulb from box, discard box.

•Plug bulb into socket as shown in Figure 15.24.

Figure 15.24 Plug Bulb into Socket

•Slide light assembly back into light housing.

Figure 15.25 Replace Light Assembly

Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09 61