Quadra-Fire QVI-30FB owner manual Installing Logs and Ember Material, Installing Trim Surrounds

Step 7. Installing Logs and Ember Material

Shutter Settings

Burner	NG	LP
___________________________________________
QVI-30FB	3/8”	Full Open
___________________________________________

Positioning the Logs

The logs have been packaged separately. Refer to the installation instructions that accompany this manual. Save the log instructions with this manual.

￿If sooting occurs, the logs or glowing embers might need to be repositioned slightly to avoid excessive flame impingement.

BURNER PAN

EMBER MATERIAL

(TOP SURFACE,

AND FRONT)

Figure 13. Placement of the Ember Material

Placing the Ember Material	• Place a dime size piece of GLOWING EMBER mate-
Two separate bags of ember material are shipped with this	rial near port holes in burner top, sides and front (see
gas appliance. The bag labeled Glowing Ember (050-721)	Figure 13).
is standard glowing ember material. To place the ember	• Space dime size ember pieces about a 1/2 inch apart.
material:
• Remove the glass door from the unit (see Figure 12).	Never press embers into burner ports. Do not cover burner
	ports. Place dime size pieces around front and sides of
	burner pan.
	• Save the remaining ember materials for use during fire-
	place servicing. The embers provided are sufficient for 2
	to 4 applications.
	• Place MYSTIC EMBERS over burner surface and around
	base of the burner, do not cover any burner port holes.
PULL AND	Can be used on floor of firebox for a realistic ash-bed.
RELEASE
CLIPS TO OPEN	• Replace the glass door on the fireplace.
Figure 12. Glass Assembly	• Re-install and latch the decorative front.

Step 8. Installing Trim Surrounds

Combustible materials MUST NEVER overlap onto the front face.

1.Find the coiled low voltage wires and ON/OFF switch attached to outer right side of the insert (see Figure 14).

2.Disconnect the ON/OFF switch from the low voltage wire leads, and insert the ON/OFF switch through the hole at the upper right corner of the surround - it will be retained in the hole.

		LOCATING
		TABS					FIREBOX
						ON/OFF
						SWITCH
						SURROUND
						WITH TRIM
Figure 14.
Quadra-Fire	•	QVI-30FB	•	2020-900	Rev. H	• 9/07	19