Scalar i500 Getting Started Guide 13
Step 4: Install the Module Components
For instructions on any of the following steps, see “Adding, Removing, and Replacing” in the Scalar i500
User’s Guide.
1If not already installed, install the library control blade (LCB) in the control module.
2Install the tape drives.
3Install the power supplies.
4Install the Fibre Channel (FC) I/O blade (if required and not already installed).
5Close the library’s I/E station door and access door.
Step 5: Connect the Tape Drive Cables
Follow the instructions below for the type(s) of tape drives installed in your library. The instruction sets are:
Connecting Parallel SCSI Cables
Connecting Fibre Channel Cables Directly to Host or Switch
Connecting Fibre Channel Cables Through an I/O Blade
Connecting Serial Attached SCSI (SAS) Cables
A library can have any combination of SCSI, FC, and SAS drives, connected directly to hosts or thr ough I/
O blades. You may need to follow more than one set of instructions below. For more detailed instructions,
see the Scalar i500 User’s Guide.