Quantum TC2201 manual Configuration Restore Procedure

Configuration Restore Procedure

Backup/Restore Configuration Settings

The default IP address is 1.1.1.1.

Note: If the TC2201 is to use a static IP address, the default IP address 1.1.1.1 should be changed to an address that is appropriate for the IP network it will reside on. Note that the default IP address can be used in a direct connection between the TC2201 and the host computer via a crossover Ethernet cable.

Note: You may also need to specify the directory location on your computer or network where your FTP program will store the backup file.

3Enter the user name and password. The default values for user name and password are root for the user name and password for the password.

4Specify binary mode: bin

5Specify the filename (.cfg file) with the get command: get filename.cfg

(where “filename.cfg” can be any name for the configuration file.)

The file will transfer to the current directory specified on your computer’s FTP utility. If running FTP from a DOS or Linux command line, the destination directory can be set using the lcd command (ex. lcd c:\myCfg).

Note: World Wide Name (WWN) values and Ethernet physical address (MAC address) values will not be saved. Because user defined values for these settings are not retained in the configuration backup file, they must be re-entered after the configuration is restored. See the Configuration Restore Procedure later in this chapter for more information.

To restore a configuration file:

1Connect the TC2201 to the ethernet network used by your computer.

2Start your FTP program using the TC2201’s IP address:

Quantum TC2201 User’s Guide 124