Quatech DS-102 user manual Modem Status Register, Scratchpad Register

MODEM STATUS REGISTER

This register is located at I/O address [base+6]. It reports on the status of signals coming from the modem or equipment used in place of a modem. It allows the current states of "modem control signals" to be sensed. These signals include the DCD (Data Carrier Detect), RI (Ring Indicator), DSR (Data Set Ready), and CTS (Clear To Send).

The Modem Status Register also provides change information for each of these signals. When a modem control signal changes state, the appropriate change bit is set to logic 1. The change bits (3, 2, 1, and 0) are reset to logic 0 whenever the Modem Status Register is read.

A modem status interrupt is generated whenever any of bits 3, 2, 1 or 0 is set by the UART to a logic 1.

BIT	DESCRIPTION
7	DCD --- Data carrier detect:
	Complement of the DCD input.
6	RI --- Ring indicator:
	Complement of the RI input.
5	DSR --- Data set ready:
	Complement of the DSR input.
4	CTS --- Clear to send:
	Complement of the CTS input.
3	DDCD --- Delta data carrier detect:
	Indicates the Data Carrier Detect input has changed state.
	Cleared when this register is read.
2	TERI --- Trailing edge ring indicator:
	Indicates the Ring Indicator input has changed from a low to a high
	state.
	Cleared when this register is read.
1	DDSR --- Delta data set ready:
	Indicates the Data Set Ready input has changed state.
	Cleared when this register is read.
0	DCTS --- Delta clear to send:
	Indicates the Clear to Send input has changed state.
	Cleared when this register is read.
	Figure 23 --- Modem Status Register bit definitions

SCRATCHPAD REGISTER

This register is located at I/O address [base+7]. It is not used by the 16450 or 16550. It may be used by the programmer for temporary data storage. The Scratchpad Register is eight bits wide and can be read or written.

22 Quatech DS-102 User's Manual