2.2.1 Command Line Options

To configure a SSP-100 in the system, the Enabler requires one command line argument from the user to determine the configuration of the card. This argument must be enclosed in parentheses and within the argument, any or all of the following parameters may be specified using a comma (no spaces) to separate each parameter:

Ssocket specifies which PCMCIA socket the SSP-100 must be inserted into for this configuration argument to be used. socket must be in the range 0 - 15. This option is required if the 'R' option is not used.

Baddress

specifies the base I/O address of the SSP-100 in hexadecimal. This address

 

must reside on an even 8-byte boundary. This option is required if the 'R'

 

option is not used.

Iirq

specifies the interrupt level (IRQ) of the SSP-100 in decimal. irq must be one

 

of the following values: 3, 4, 5, 7, 9, 10, 11, 12, 14, 15, or 0 if no IRQ is desired.

 

This option is required if the 'R' option is not used.

Waddress specifies the base address of the memory window required to configure the SSP-100. Set address = D0 for a memory window at segment D000, address = D8 for a memory window at segment D800, etc. Valid settings for address are C8, CC, D0, D4, D8, and DC. If this option is omitted, a memory window at segment D000 will be used.

Ebios specifies which location the configured SSP-100 will be placed in the BIOS equipment list. Valid numbers are 1-4. If this option is omitted, the SSP-100 will not appear in the BIOS equipment list. If no number is specified, the SSP-100 will be placed in the next available location in the BIOS equipment list. The “A” switch must not be used when using this command.

Acom specifies which Logical COM port the SSP-100 will be configured. Valid COM port numbers would be 1-4. The BIOS Equipment list will be automatically updated, so the E command is not required when using this option. If no number is specified, the SSP-100 will be configured as the next available COM Port using the standard base address and IRQ settings for that COM port. If this option is omitted, the user must either specify a base address or IRQ setting for the SSP-100 or allow Card and Socket Services to select a base address and IRQ to configure the card. When the “A” command is used, the “B”, “I”, and “E” commands must not be used.

SSP-100 User’s Manual

2-9

Page 18
Image 18
Quatech SSP-100 user manual Option is not used