Chapter 4 - Control from the Supervisory Port HCD-E1
Installation & Operation Manual
4-18 HCD-E1 Command Set Description 11/01/00 19:23
Display Fields
The agent parameters displayed on the data form, their range of values and
description of how to change them are as follows:
TELNET_APATHY_TIME Press the F or B keys to select the time, in minutes,
after which a Telnet connection will be automatically
terminated if no incoming activity is detected.
The available values are 10MIN, 15MIN, and 20MIN.
Default is 10MIN.
IP ADDRESS Type in the IP address assigned to the HCD-E1 SNMP
agent in the dotted-quad format (four three-digit
numbers in the range of 000 through 255, separated by
periods).
READ COMMUNITY Type in the name of the SNMP community that has
read-only authorization (the HCD-E1 SNMP agent will
accept getRequest and getNextRequest commands only
from management stations using that community). You
may enter up to 32 alphanumeric characters.
WRITE COMMUNITY Type in the name of the SNMP community that has
read-write authorization (the HCD-E1 SNMP agent will
also accept setRequest commands from management
stations using that community). You may enter up to 32
alphanumeric characters.
TRAP COMMUNITY Type in the name of the SNMP community to which
the HCD-E1 SNMP agent will send traps. You may
enter up to 32 alphanumeric characters.
Note
For explanation of the terms see Appendix A.
DEF BERT Purpose
Define the BERT test conditions.
Syntax
DEF BERT CH X
Use
1. Type the following:
• To define the BER test parameters for channel 1:
DEF BERT CH 1<CR>
• To define the BER test parameters for channel 2:
DEF BERT CH 2<CR>