Installation
CAUTION
You must use
!a Class 2 power source
that supplies 9V DC and delivers at least 350 mA. Its center tip must be set to positive and its plug must fit the phone’s DC IN 9V jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the phone or the adapter.
On a Desk Top
1.Insert the two tabs at the top of the narrow end of the supplied bracket into the base’s upper tab slots, then press down on the bracket’s latches and insert them into the lower slots.
2.Connect the handset cord to left side of the phone and corded handset.
3.Plug one end of the supplied long modular cord into the TEL LINE jack on the back of the base.
4.Plug the modular cord’s other end into a modular phone line jack.
5.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back of the base.
6.Route the adapter’s cord through the strain relief slot on the base, then plug the adapter into a standard AC outlet.
7.Lift the base’s antenna to a vertical position.
10
