![](/images/new-backgrounds/1295104/29510419x1.webp)
keyhole slots with the wall plate studs and slide the base down to secure it.
5.Plug the adapter into a standard AC out- let.
6.Lift the base’s antenna to a vertical posi- tion.
On a Wall
To mount the TAD directly on a wall, you need two screws of at least 13/8 inch long (not supplied) with heads that fit into the key- hole slots on the bottom of the base.
1.Drill two holes 315/16 inches (100 mm) apart. Then thread a screw into each hole, letting the heads extend about 1/8 inch (3 mm) from the wall.
2.Plug one end of the supplied long modu- lar cord into the base’s TEL LINE jack.
3.Insert the supplied AC adapter’s barrel plug into the base’s DC IN 9V jack.
4.Route the adapter cable and modular cords through the grooves on the base.
5.Align the base’s keyhole slots with the mounting screws and slide the base down to secure it.
6.Plug the modular cord’s other end into the phone jack.
7.Plug the adapter into a standard AC out- let.
8.Lift the base’s antenna to a vertical posi- tion.
CONNECTING, CHARGING, AND REPLACING THE BATTERY PACK
The phone comes with a rechargeable
1.Press down and slide off the battery pack compartment cover.
2.Lift the battery pack out of the compart- ment.
3.Plug the battery pack's connector into the socket in the compartment, (the con- nector fits only one way), replace the battery pack, and replace the cover.
To charge the battery pack, place the hand- set either faceup or facedown on the base. The CHARGE/IN USE indicator on the base lights.
Note: Be sure the battery pack is properly connected before you try to charge it. The CHARGE/IN USE indicator lights when the handset is on the base even if the battery pack is not properly connected.
Recharge the battery pack when Bemý8Wjj[ho flashes on the display.
Notes:
•When you first use the phone after charging or recharging the battery pack, the phone might not work and you might
10 | Installation |