If the dial tone stops, you have
To set the dial mode, press TALK to hang up the phone if necessary, then hold down FLASH until the phone beeps and the current dialing mode, tone or pulse, appears. Then press # to set pulse mode or ∗ to set tone
mode. The phone beeps and displays Fkbi[ :_Wb_d] or Jed[ý:_Wb_d], then the display clears.
Note: The phone exits setting mode if a call or page is received, or if you press TALK.
If the battery pack power gets too low, the dial mode might reset to tone. If you are on a pulse line and cannot make a call, try setting the dialing mode to pulse.
SETTING THE HANDSET’S RINGER TONE/VOLUME
You can select one of four different ringer tone/volume settings on the handset. At any time, except during a call, repeatedly press VOL/CID 8 or 9 to select the desired ringer setting. Each time you press a button, the phone rings at the selected setting and H_d][h 7ý>_]^, H_d][hý7ýBem, H_d][hý8ý>_]^, or H_d][hý8 Bem appears.
You can also turn off the ringer. At any time,
except during a call, hold down VOL/CID 9 until the phone beeps and H_d][hýE\\ appears. When you place the handset faceup on the base, 2H_d][hýE\\4 appears.
You can still make or receive a call even when the ringer is turned off. When you have
an incoming call, any other phone connected to the same line rings, and ?dYec_d]ý9Wbb ap- pears on the handset’s display.
To turn the ringer back on, simply press VOL/ CID 8 or 9. The ringer is restored at the RINGER A HIGH setting.
TURNING THE BASE’S RINGER ON/OFF
You can set the base’s ringer to high or low, or turn it off. At any time, except during a call, press SET/RING. Each time you press the button, the phone rings at the selected set- ting (or does not ring at the OFF setting). The display shows >_, Be, or E\. When you set the ringer to off, the RINGER OFF indicator lights.
Even when you turn off the base’s ringer, you can still make or receive calls using this phone. Telephones on the same line (and the handset if it is away from the base and its ringer is turned on) still ring when there is an incoming call.
You can also set the ringer in the menu set- ting mode (see “Using the Menu Button” on Page 23).
1.Press MENU four times. The phone announces “Ringer volume” followed by its current setting. The display also shows the current setting.
2.Press SET/RING to enter the setting mode.
3.Press SKIP or REPEAT to change the setting.
4.Press SET/RING to store the setting.
5.Press STOP to exit the menu setting mode.
SETTING AUTO TALK
Your phone is preset with Auto Talk off, so you must press TALK to answer a call. With Auto Talk turned on, you can answer a call by lifting the handset from the base or, if the handset is away from the base, by pressing any key.
12 | Installation |
