•After dubbing, if a program is stored, both gof the PLAYBACK tray and g/ ENTER of the RECORD/PLAYBACK tray allow you to play the programmed tracks.

Dubbing a CD from a Selected Track to the Last Track

Instead of dubbing the entire source disc from the beginning to the end, you can dub tracks from a selected track to the last track.

You can select from the first track to the last track so the CD recorder dubs all the disc yet it does not finalize the disc in the RECORD/PLAYBACK tray at the end of the dubbing.

1.In the stop mode after installing discs, select the track you want to start from.

2.Press DUBBING MODE to select a dubbing speed then press g/ENTER.

3.At the end of the dubbing, PMA WRITE then COMPLETE appears.

4.Repeat Steps 1–3 above if you want to dub additional tracks.

Basic Recording

This section describes the basics of recording from external sources.

1.Set a recordable CD-R/RW disc in the RECORD/PLAYBACK tray. When a blank disc is set in the RECORD/ PLAYBACK tray, BLANK appears.

2.Select the source to be recorded. Every time you press INPUT SELECTOR, the input changes as follows:

DIGITAL OPTICAL (OPTICAL and DIGITAL light at the right of the peak level meter): use to record from a source connected to the DIGITAL IN (OPTICAL) terminal.

DIGITAL COAXIAL (DIGITAL and COAXIAL light at the right of the peak level meter): To record a source connected to the DIGITAL IN (COAXIAL) terminal.

ANALOG (ANALOG lights at the right of the peak level meter): use to record from a source connected to LINE IN jacks.

Note: If you select a digital input which is not connected to the CD recorder, D-UNLOCKbriefly appears.

3.Adjust the recording level. See “Setting the Recording Level” on Page 24.

4.Select the mode of track number assignment by pressing AUTO/ MANUAL. See “Assigning Track Numbers to Recordings” on Page 25.

5.Press RECORD. BUSY then READY

appears. The CD recorder enters record pause mode. † and REC flashes.

6.Press g/ENTER of the RECORD/ PLAYBACK tray to start recording. Play the source to be recorded.

If the CD recorder detects copy-prohibit signals during recording, CAN’T COPY appears and recording stops.

7.Press † to temporarily pause recording. To restart recording, press g/ENTER.

23