Radio Shack CD Player Troubleshooting, Problem, Solution

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be resolved by following the suggested remedies below, take the CD recorder to your nearest local RadioShack store.

This CD recorder has been manufactured to the specifications of RadioShack and is covered by a limited warranty from RadioShack. If your CD recorder is not operating as it should, take it to your local RadioShack store or call 1-800-THE-SHACK for assistance.

Problem	Solution
No power.	Check the connection to the AC power supply.
No sound from speakers.	Check the connection to the stereo system.
	No disc has been loaded. Load a disc.
The sound is noisy.	The CD recorder is too close to a TV set or similar appliances.
	Install the CD recorder away from TV’s and other electronic
	devices or turn the devices off.
Remote control does not	Check the batteries and replace them if necessary.
work.
	Use the remote control within the range of 15 ft./5m and point
	at the front panel.
	Clear obstacles between the remote control and the CD
	recorder.
	If a fluorescent light is near the CD recorder, turn it off.
Does not play.	Load a disc with the label side up.
	If the disc is dirty, clean the surface on the disc.
	A blank disc has been loaded. Load a pre-recorded disc.
Sound skips.	Place the CD recorder in a stable place to avoid vibration and
	shock.
	If the disc is dirty, clean the surface of the disc.
	Do not use scratched, damaged, or warped discs.
The recording level is too	Adjust the recording level.
low.
	Check the connected components. If the CD recorder still does
	not operate normally, unplug the power cord from the outlet
	and plug it in again.

29