43-1101.fm Page 8 Friday, July 9, 1999 9:32 AM

Notes:

When you first use the phone after charging or recharging the battery pack, the phone might not work and you might hear error tones (three beeps).

If you hear the error tones, return the keypad to the base for about 5 sec- onds to reset the security access- protection code.

About once a month, fully discharge the battery pack by keeping the phone off the base until the LOW BATT indicator flashes. Otherwise, the battery pack loses its ability to fully recharge.

If the battery pack becomes com- pletely discharged or the base loses power while the handset is away from it, the security access-protection code needs to be reset. To reset the securi- ty code, place the handset on the base for about 5 seconds. If it was the handset that lost power, leave it on the base to charge the battery pack.

If you are not going to use your phone for an extended period of time, dis- connect its battery pack. This helps increase the battery pack’s usable life.

ATTACHING THE HEADSET

If the CHARGE/IN USE indicator does not light when you place the keypad on the base, be sure the battery pack and AC adapter are cor- rectly and securely connected. Also, check the charging contacts on the keypad and base. If the contacts are dirty or tarnished, clean them with a pencil eraser.

Charging Contacts

Charging Contacts

HOLDER

Insert the tabs on the headset holder into the slots on the base and snap it into place.

8

Page 8
Image 8
Radio Shack ET-1101 owner manual Attaching the Headset, Holder