MOUNTING THE BASE DIRECTLY ON THE WALL
For this mounting method, you need two
1. Drill | two | holes | 3 | 15 | 5/16 | |||||||
| /16 |
|
|
|
|
|
|
| ||||
inches (100 mm) apart. | ||||||||||||
Then | thread a | screw |
|
|
|
| ||||||
|
|
|
| |||||||||
into each | hole, | letting |
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| ||||||
the | heads | extend |
|
|
|
|
|
| ||||
about | 5/16 | inch (7 mm) |
|
|
|
|
|
| ||||
|
|
|
|
| ||||||||
from the wall. |
|
| 315/16 |
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
4.Insert the supplied power adapter’s barrel plug into the DC 12V jack on the back of the base.
2.Remove the bracket by holding in both tabs and gently pulling out the wide end of the bracket.
3.Plug one end of the supplied long modular cord into the phone jack on the back of the base.
5.Route the modular cord through ei- ther groove on the bottom of the base and the adapter cord through the groove below the strain relief slot.
11
