Radio Shack ET-689 owner manual Connecting and Charging the Battery Pack

43-689.fm Page 10 Thursday, September 16, 1999 10:22 AM

3.If you have a single 2-line modular jack, plug one end of the supplied long 2-line modular cord into L1 OR L1/L2 on the back of the phone’s base.

Note: When you make this connec- tion, do not connect another modu- lar cord to the L2 jack. Otherwise, the phone will not operate properly.

If you have two separate 1-line mod- ular jacks, plug one end of the sup- plied 2-line long modular cord into L1 OR L1/L2 and plug the supplied 2- line long modular cord into L2.

If you have a single 1-line modular jack, plug one end of either supplied long modular cord into L1 OR L1/L2 to use line 1, or into L2 to use line 2.

4.Plug the supplied AC adapter’s bar- rel plug into the DC 12V jack.

5.Route the adapter’s cord through the right groove on the bottom of the base. Route the long modular cord through the left groove on the bot- tom of the base.

If you have connected two long modular cords, route the cord con- nected to L1 OR L1/L2 through the right groove on the bottom of the base, and route the cord connected to L2 through the hole in the center of the bracket.

6.Insert the tabs on the narrow end of the bracket into the slots on the base’s bottom as shown, then push the tabs on the wide end of the bracket until it clicks securely into place.

10

7.Plug the AC adapter into a standard AC outlet.

8.Plug the other end(s) of the cord(s) into a modular phone line jack(s).

9.Align the base’s keyhole slots with the mounting screws and slide the base downward to secure it.

10.Lift the base’s antenna to a vertical position.

CONNECTING AND CHARGING THE BATTERY PACK

The ET-689 comes with a rechargeable nickel-cadmium battery pack in the handset but not connected. Before using your phone, you must connect the bat- tery pack, then charge it for about 15 hours.

1.Press down and slide off the battery compartment cover.