43-689.fm Page 20 Thursday, September 16, 1999 10:22 AM
Problem | Suggestion | |
|
| |
|
| |
The handset does not ring or | Fully extend the base’s antenna and place it in | |
receive a page. | a vertical position. | |
|
| |
| Move the handset closer to the base. | |
|
| |
| Move the base away from other electrical | |
| devices. | |
|
| |
| Return the handset to the base to recharge the | |
| battery pack. | |
|
| |
The handset stops working or | Move the handset closer to the base. | |
works poorly during a call. |
| |
Fully extend the base’s antenna and place it in | ||
| ||
| a vertical position. | |
|
| |
| Return the handset to the base for 6 seconds | |
| to reset the handset. | |
|
| |
| Be sure the handset’s battery is charged. (If | |
| the battery power is too low, it might not have | |
| enough power to light the BATT LOW indica- | |
| tor.) | |
|
| |
| If the base loses power while the handset is | |
| away from it, the security | |
| code might change. Restore power to the | |
| base, then place the handset back on the | |
| base. The CHARGE indicator on the base | |
| lights, indicating that the code is set again. | |
|
| |
The indicators for Lines 1 and | Check that the phone line cord(s) and the AC | |
2 on your handset flash, but | adapter are properly connected at both ends. | |
there is no dial tone. |
| |
Check to see if both lines are on hold. | ||
| ||
|
| |
The Line 1 or Line 2 indicator | Only one phone line is connected. Check that | |
continuously flashes when you | both phone lines are properly connected. | |
are not using the phone. |
| |
|
|
If you still have problems, disconnect the phone. If other phones on the same line(s) work properly, the fault is in this phone or its installation. If you cannot find the prob- lem, take your phone to your local RadioShack store for assistance.
20
