If you need to connect a long modu- lar cord to the L2 jack, remove the short modular cord from the left groove and route the long modular cord through the groove on the bot- tom of the base.
5.Route the end of the short modular cord through the hole in the center of the bracket, then insert the tabs on the narrow end of the bracket into the upper slots on the base’s bot- tom.
8.Plug the short modular cord into the wall plate jack, then align the base’s keyhole slots with the wall plate studs and slide the base downward to secure it.
If you attached a long modular cord, plug it into the other phone line jack.
9.Lift the base’s antenna to a vertical position.
Directly on a Wall
For this mounting method, you need two screws (not supplied) with heads that fit into the keyhole slots on the mounting bracket.
6. Route the adapter cord and the long |
modular cord (if you have connected |
it) through each slot on the bottom |
of the wide end of the bracket, then |
push the tabs on the wide end of the |
1.At the desired mounting
location, drill two holes 315/16 inches (100 mm) apart vertically. Then thread a screw into each
hole, letting the heads extend about 3/16 inch (5 mm) from the wall.
3
/16
15
3/16
bracket into the other slots until the |
bracket clicks securely into place. |
7. Plug the AC adapter into a standard |
AC outlet. |
2.Remove the bracket by holding in both tabs on the wide end, then gen- tly pulling out the wide end of the bracket.
9
