Setting the Scan Resume Delay
When you set the scan resume condition to cr (carrier), the HTX- 242 resumes scanning after the carrier drops. The scan resume delay option lets you set the
Follow these steps to change the scan resume delay.
1.Press VFO.
2.Hold F for at least 1 second. FUNC flashes.
3.Press MR.
4.Repeatedly press ▲ until the
5.Rotate TUNE, or press UP or DOWN on the microphone, to select the desired scan resume delay.
6.Press MR or PTT to save the setting.
Setting the Scanning Range
When you scan in a VFO mode, the
Follow these steps to change the scanning range.
1.Press VFO.
2.Hold F for at least 1 second. FUNC flashes.
3.Press MR.
4.Repeatedly press ▲ until the
5.Rotate TUNE, press UP or DOWN on the microphone, or directly enter the lower scan limit’s last five digits on the microphone’s keypad.
6.Press ▲. The
7.Rotate TUNE, press UP or DOWN on the microphone, or directly enter the upper scan limit’s last five digits on the microphone’s keypad.
8.Press MR or PTT to save the settings.
Note: The frequency gap between the lower and upper scan limits should ! be no less than two times the current frequency step. If the frequency gap
is less than this, the
21
