Mounting the HTX-242 in a Vehicle | Radio Shack specification

Mounting the HTX-242 in a Vehicle

When you select a mounting location for the HTX-242, be sure:

•You can easily reach it

•No wires or cables will interfere with the vehicle’s operation

•It is not directly in front of heating vents

•All wires will reach their connection points

Cautions:

•To avoid damaging your vehicle’s electronic systems, contact your vehicle’s manufacturer before you install the HTX-242 to find out about the proper transceiver mounting locations, antenna loca- tions, and power and antenna cable routing guidelines.

•Do not apply power to the transceiver until after you properly mount and connect an antenna.

Use the supplied screws, metal washers, bracket, rubber washers, and mounting knobs, as shown, to mount the transceiver.

7

Image 7

Radio Shack owner manual Mounting the HTX-242 in a Vehicle

Contents

HTX-242 TWO-METER Mobile Trans Ceiver Introduction Features Using this Manual Contents Specifications Schematics Using Memory ChannelsUsing Dtmf and Subaudible Tones Using the Menu Troubleshooting Connecting the Microphone InstallationUnpacking the Transceiver Mounting the HTX-242 in a Vehicle Connecting an Antenna Connecting to your Vehicle’s Power Using the HTX-242 as a Base Station Connecting an External Speaker Optional Using the HTX-242 with Packet Radio Understanding the HTX-242 Dtmf Touch-Tone FeaturesDual VFO Modes Repeater Operation Subaudible Tone Ctcss FeaturesMemory Channels VFO-A-T Understanding the DisplayPage Extending the Transmit Frequency Range Resetting the HTX-242Basic Operation Turning On/Off Your HTX-242 Locking the Controls Setting Volume and SquelchUsing the Light Setting the Power Level Selecting a Frequency Tuning to a FrequencyDirectly Entering a Frequency Scanning for a Frequency Setting the Frequency Step Setting the Scan Resume Condition Setting the Scan OptionsStoring Scan Skip Frequencies Setting the Scanning Range Setting the Scan Resume Delay Transmitting Receiving Transmissions Transmitting Dtmf Tones from Memory Manually Transmitting Dtmf Tones Limiting Transmit Duration Turning the Keytone Beep On and Off Receive Frequency Transmit Offset Frequency Offset DefaultsAdvanced Operation Turning Auto Duplex On and Off Reversing the Offset Changing the Default OffsetOverriding the Duplex Offset Using the Dual VFOs for Duplex Operation Changing Stored Settings Using Memory ChannelsStoring a Frequency Using Auto Memory Store AMS Using the Calling-Frequency Memory Tuning to a Standard Memory ChannelChecking Priority Channel Clearing a Memory Channel Scanning Memory ChannelsEnabling/Disabling Scanning for Memory Channels Storing a Dtmf Sequence Using Dtmf and Subaudible TonesTransmitting a Dtmf Sequence Using Group Calling Using DtmfName Assignment Dtmf Page Sequence Using Auto-Reply Using Dtmf Auto Send Code Freq. Hz Using Subaudible TonesSetting the Subaudible Tones Valid Subaudible Tones Activating Subaudible Tone Transmit and Squelch Setting the Dtmf Page and Subaudible Tone Alert Using the Menu OFF Menu Default Explanation/Available Settings Option Problem Possible Solutions TroubleshootingError Codes Common Problems and Solutions Replacing the Fuse General SpecificationsReceiver Transmitter Schematics RF Schematic Digital Schematic Microphone Schematic Radio Shack Division of Tandy Corporation Fort Worth, Texas