Using the HTX-242 as a Base Station | Radio Shack manual

Using the HTX-242 as a Base Station

Although we designed the HTX-242 primarily for use as a mobile transceiver, you can also use it as a base station. To do so, you need these items:

•13.8-Volt DC regulated power supply that can supply at least 10 amps continuous power

•Base station antenna

•50-ohm coaxial antenna cable and connectors

Follow these steps to connect the HTX-242 as a base station.

1.Mount the base station antenna according to its instruc- tions.

Warning: For your safety, follow all cautions and warnings included with the base station antenna.

2.Connect the antenna cable to the antenna jack on the back of the HTX-242.

3.Connect the black power wire to the power supply’s negative

(–) terminal.

4.Connect the red power wire to the power supply’s positive (+) terminal.

5.Connect the power supply to a source of power.

10

Image 10

Radio Shack owner manual Using the HTX-242 as a Base Station

Contents

HTX-242 TWO-METER Mobile Trans Ceiver Features Introduction Using this Manual Contents Using the Menu Troubleshooting Using Memory ChannelsUsing Dtmf and Subaudible Tones Specifications Schematics Connecting the Microphone InstallationUnpacking the Transceiver Mounting the HTX-242 in a Vehicle Connecting an Antenna Connecting to your Vehicle’s Power Using the HTX-242 as a Base Station Using the HTX-242 with Packet Radio Connecting an External Speaker Optional Understanding the HTX-242 Dtmf Touch-Tone FeaturesDual VFO Modes Repeater Operation Subaudible Tone Ctcss FeaturesMemory Channels Understanding the Display VFO-A-TPage Turning On/Off Your HTX-242 Resetting the HTX-242Basic Operation Extending the Transmit Frequency Range Setting the Power Level Setting Volume and SquelchUsing the Light Locking the Controls Selecting a Frequency Tuning to a FrequencyDirectly Entering a Frequency Setting the Frequency Step Scanning for a Frequency Setting the Scan Resume Condition Setting the Scan OptionsStoring Scan Skip Frequencies Setting the Scan Resume Delay Setting the Scanning Range Receiving Transmissions Transmitting Manually Transmitting Dtmf Tones Transmitting Dtmf Tones from Memory Turning the Keytone Beep On and Off Limiting Transmit Duration Turning Auto Duplex On and Off Frequency Offset DefaultsAdvanced Operation Receive Frequency Transmit Offset Reversing the Offset Changing the Default OffsetOverriding the Duplex Offset Using the Dual VFOs for Duplex Operation Changing Stored Settings Using Memory ChannelsStoring a Frequency Using Auto Memory Store AMS Using the Calling-Frequency Memory Tuning to a Standard Memory ChannelChecking Priority Channel Clearing a Memory Channel Scanning Memory ChannelsEnabling/Disabling Scanning for Memory Channels Storing a Dtmf Sequence Using Dtmf and Subaudible TonesTransmitting a Dtmf Sequence Using Group Calling Using DtmfName Assignment Dtmf Page Sequence Using Auto-Reply Using Dtmf Auto Send Valid Subaudible Tones Using Subaudible TonesSetting the Subaudible Tones Code Freq. Hz Setting the Dtmf Page and Subaudible Tone Alert Activating Subaudible Tone Transmit and Squelch Using the Menu Menu Default Explanation/Available Settings Option OFF Common Problems and Solutions TroubleshootingError Codes Problem Possible Solutions Replacing the Fuse General SpecificationsReceiver Transmitter Schematics RF Schematic Digital Schematic Microphone Schematic Radio Shack Division of Tandy Corporation Fort Worth, Texas